Buy Low Price From Here Now
Large face clamp reaches up to 6" and ensures a perfectly flush joint every time! Large pad keeps clamp from marring wood. Perfect for flat stock such as face frames, mitered picture frames and other similar joints.
Readmore
Technical Details
- Securely holds work pieces at a 90 degree angle- Two arms swivel to adjust to work piece dimensions and anchor work pieces
- 4-1/2 inch reach for added flexibility
- Easy release handle simplifies operation
See more technical details
By Gordo
The Kreg Right Angle Clamp is an essential tool for someone doing a full range of pocket hole joinery. It is easy and precise to use. The rubber coated handles provide good and comfortable grip. It does an excellent job of pulling right angle joints together before installing the screws.
By J. Tsai (Bellevue, WA)
Its a simple tool and does its job. It is helpful for clamping pieces of wood together when you are joining wood for pocket holes or even for gluing.
By Pax Draconis (Breesport, NY)
I got the Kreg Jig for my birhtday, I really could have used the Kreg RAC but the folks who I was going to buy it from ran out. I know that IF I ever get my hands on this product I will give it a solid "FIVE" stars.
By Tommassini (California, USA)
Well worth the investment! On advice from others I bought two for constructing a bath vanity. They held the plywood panels together very snugly to counteract the Kreg screws tendency to pull a panel slightly inward.
By New England Yankee (Northern New England)
This clamp works flawlessly every time. Conceptually, it's very simple. It replaces one of the flats on a normal Kreg clamp with a pin that fits in the pocket hole. Use the clamps in one or more pocket holes while you drive the screws into the others. If you need 100% square accuracy, you can hold a square in place against the joint while you drive the screw.
By the way, you can use these to clamp items that are not flush to one another, e.g., frame reveals, parts with differing thicknesses, and inset panels. Try THAT with a corner clamp!
To the reviewer that wondered about using pocket holes on the outside of items: In cabinet making, it's the INSIDE of the cabinet that's the concern. The ply or particleboard sides and back of the cabinet are completely hidden for most cabinets and virtually always covered on end cabinets.
As to the review that talks about blowing out the pocket hole, the only things that could possibly cause that are drilling too small a pocket (the clamps work perfectly with Kreg drills), clamping so tight as to crush the pocket, or clamping at an extreme angle (the clamp will work at a range of angles, not just 90 degrees). Or perhaps the owner has a defective clamp. In any event, this is a highly unusual complaint, and I've yet to hear from anyone else with this problem. Trust your own judgement, though, go to a demo at a woodworking show or store and try them.
Images Product
Buy Kreg RAC Right Angle Clamp Now
ไม่มีความคิดเห็น:
แสดงความคิดเห็น